CAN Transceivers for Robotics

文章附图

Robot CAN bus PCB with CAN transceiver, termination resistors and protection componentsCAN communication circuit for robotic motor, sensor and joint control networks

Product Overview

A CAN Transceiver is a physical-layer communication IC thatconnects a microcontroller’s CAN controller to the CAN bus. It converts thecontroller’s digital transmit and receive signals into robust differential CANHand CANL signals suitable for communication through twisted-pair cables.

CAN transceivers are widely used in robotic systems becausethey support reliable, real-time multi-node communication in electrically noisyindustrial environments.

Key Functions

  • Converts MCU logic     signals into CAN differential signals

  • Receives CANH and CANL     signals from the bus

  • Supports bidirectional     communication

  • Improves noise immunity     through differential signaling

  • Connects multiple     controllers to the same communication bus

  • Supports fault reporting     and system diagnostics

  • Provides standby or     low-power operating modes

  • Helps protect     controllers against bus transients

  • Supports deterministic     real-time control networks

Typical Applications

  • Humanoid robot joint     networks

  • Industrial robotic arms

  • Collaborative robots

  • AGVs and autonomous     mobile robots

  • Motor-driver and     servo-control systems

  • Battery-management     systems

  • Sensor networks

  • Power-distribution units    

  • Safety and diagnostic     controllers

  • Service and inspection     robots

Main CAN Transceiver Signals

Signal

Function

TXD

Receives transmit data from the  MCU’s CAN controller

RXD

Sends received bus data to the  MCU

CANH

High side of the differential  CAN bus

CANL

Low side of the differential  CAN bus

STB/EN

Controls standby or operating  mode

VCC

Main transceiver power supply

VIO

Optional logic-level supply

GND

Electrical reference and return  path

Main Components on the CAN PCB

CAN Transceiver

The CAN transceiver converts TXD and RXD logic signals intoCANH and CANL differential bus signals. It is the electrical interface betweenthe MCU and the external CAN network.

Microcontroller

The MCU normally contains the CAN protocol controller. Itcreates CAN frames, handles message identifiers, performs error checking andprocesses received data.

Common-Mode Choke

Reduces common-mode noise and electromagnetic emissions onthe CANH and CANL lines while preserving the differential communication signal.

Termination Resistors

A CAN network normally uses 120Ω termination at eachphysical end of the main bus. Split termination may use two 60Ω resistors and acenter capacitor to improve EMC performance.

TVS and ESD Protection

CAN-rated protection devices suppress electrostaticdischarge and transient voltage caused by cables, motors and other inductiveloads.

Decoupling Capacitors

Provide stable local power to the transceiver and reducehigh-frequency supply noise.

Power Regulator

Converts the robot’s available voltage into the supplyvoltage required by the MCU and CAN transceiver.

Connectors

Locking connectors carry CANH, CANL, ground and optionalpower. Two connectors may be used to support daisy-chain wiring.

Twisted-Pair Cable

CANH and CANL are routed as a twisted pair to improve noiseimmunity and reduce electromagnetic radiation.

Termination Jumper

Allows the termination resistor to be enabled only when theboard is installed at one end of the CAN bus.


Global Product Inquiry
Custom PCB Fabrication, PCBA Assembly & Component Procurement Solution
Inheriting the Ant Spirit, Building Core Competitiveness in Electronic Supply Chain with Professionalism & Dedication.
PRODUCT
CONTACT
+86-13902944251 judy@atftek.com